I've had an M93B stock for a while and it is about to be attached to my AR15Armory.com lower today. I've half way attempted to put the three-point sling adapter on the stock but the holes on the "base" part of the stock aren't tapped and the screws won't go completely through the nuts. Any help would be greatly appreciated!


TIA,


TS

http://www.magpul.com/pdfs/mss_install_0503.pdf

The Magpul sling adaptor that I have slides between the left and right 'claws', replacing the plastic spacer "E" in the diagrams, page 8; picture on pg 15. Then the screw sandwiches them all together.
Is that the one you're using?

This post has been edited by XHairs: November 12th 2007 8:35 PM

I have that one as well, but the one I'm talking about is this one: .
It looks like I may have to disassemble the stock.

Thanks,

TS

This post has been edited by TigerStripe: November 12th 2007 8:52 PM